Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Pomona
Electric gate repair in Pomona usually means one of three things: a swing gate that’s been blown off its hinge posts by Santa Ana winds, an opener that runs but won’t move the gate, or a shared driveway where a swing gate simply doesn’t fit anymore. Our techs drive into Pomona regularly from our Corona shop and know the difference between a 1950s tract home off Garey Avenue and a craftsman bungalow near Lincoln Park. Call (877) 752-1896 and tell us what your gate is doing, or not doing, and we’ll give you a straight answer on what it takes to fix it.
Why Baron Gate Repair Is Pomona’s Preferred Electric Gate Repair Company
We’re gate specialists, not generalists. That means every tech who shows up in Pomona has spent their entire career working on gate operators, hinges, control boards, and safety systems, not splitting time between garage doors, HVAC, or whatever else came through the dispatch board that week. When you call about a LiftMaster operator that hums but won’t move, we know the likely culprits before we even see the unit: stripped arm, bad limit switch, or a capacitor that gave out after the gate got racked in a wind storm.
Pomona homeowners call us because the first visit is usually the only visit. Our Electric Gate Repair team carries common boards, arms, photocells, and remotes for the brands we service, so we’re not leaving your gate half-open while we order a part from a distributor. From the motor to the hinge, the job gets diagnosed and fixed the same day in most cases.
Nolan Briggs built Baron Gate Repair around a simple idea: work on the gate the customer already owns, understand how it was installed, and fix the root cause instead of swapping parts until something works. That’s why properties from the Fairplex-adjacent neighborhoods to Phillips Ranch call us back when a second gate or a second property needs attention.
Styles & brands we work with
Gate Opener Repair in Pomona
Gate opener repair in Pomona is our most common call, and it usually starts with a homeowner noticing the motor runs but the gate doesn’t budge, or the gate reverses halfway through its cycle. On Pomona’s older tract homes and bungalows, we often find the opener was never the real problem. The gate itself drifted out of alignment after years of heat and wind, the hinge posts sagged, and the operator has been straining against that resistance until something failed. We replace what’s broken and correct what caused it, because swapping the opener without fixing the post just means you’ll call us again in six months.
Opener Arm and Gear Replacement
When a swing gate gets caught by a Santa Ana gust and slams back, the force travels straight into the operator arm. Stripped gears, bent arms, and sheared drive pins are what we find. We stock common replacement arms and gears for LiftMaster, Mighty Mule, and DoorKing units, so most Pomona repairs are completed in a single visit rather than spread across two or three.
Limit Switch and Control Board Repairs
If your gate stops three inches short or runs past the close limit and reverses, the limit switch or the control board’s travel setting is off. On older installations around downtown Pomona, we also see boards that have taken years of heat in a metal enclosure with no ventilation. A typical gate opener board repair in Pomona runs $180 to $380 depending on the unit, and a full board replacement on a commercial-grade opener like DoorKing or FAAC can reach $450 to $700.
Automatic Gate Repair in Pomona
Automatic gate repair in Pomona covers the full system, not just the motor. That means the operator, the safety photocells, the keypad, the remote receivers, and the power run. On Pomona properties where a swing gate was crammed into a tight side yard or shared driveway, we often find the original installer skipped safety edges or placed the photocell somewhere it gets clipped by a passing car. We fix the automation and bring the safety system up to where it should be, so the gate is legal as well as functional.
Narrow Driveway Swing Gate to Slide Gate Conversions
Pomona’s older tract homes and bungalows frequently have driveways too narrow for a swing gate to clear without hitting the neighbor’s fence or car. We regularly convert these to slide gates on a rack and pinion operator. The slide gate tucks along the property line instead of swinging out, and it holds up far better to Santa Ana winds because it’s not hanging off hinge posts. A conversion like this typically runs $1,800 to $3,600 in Pomona depending on gate length, operator choice, and whether the old swing gate post footings need to be redone.
Safety Photocell and Keypad Repairs
Pomona’s hot summers and occasional winter rain take a toll on exposed safety photocells and entry keypads. Photocells get dusty, misaligned, or full of water and stop detecting objects, which makes the gate refuse to close or reverse constantly. Keypads on wrought-iron gates get baked in the sun until the keypad membrane cracks. We replace photocells, keypads, and remote receivers, and we always test the full safety circuit before we leave, because a gate that operates without a working photocell is dangerous.
Trusted Brands We Service in Pomona
We work on the brand you already have, which matters because Pomona gates run the gamut from DIY-grade Mighty Mule openers on ranch-style fences to commercial DoorKing systems on access-controlled properties near the Fairplex and industrial corridors. Our techs handle LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. We keep common boards, arms, and remotes for these brands in our service vehicles, so a Pomona call doesn’t turn into a two-week parts wait. Whether it’s a Mighty Mule on a ranch gate or a FAAC on an estate entrance, we diagnose it the same way: by understanding the system, not by guessing.
Common Electric Gate Repair Problems We See in Pomona Homes
- Santa Ana wind damage to swing gates. After a Santa Ana event, we see a spike in Pomona calls for gates blown off sagging hinge posts or latches forced open. The wind racks the gate, strips the operator arm, and yanks the hinges out of wood that was already drying and cracking. Replacing the operator without correcting the post just repeats the failure, so we re-set posts and re-align the gate before installing anything new.
- Shared driveways with no room for a swing gate. Many Pomona homes built in the 1950s through 1970s have narrow side yards and shared rights of way. A swing gate that clears fine on paper hits the neighbor’s car in practice. We convert these to slide gates on rack and pinion operators, which fit tight setbacks and keep both households’ access working.
- Hot dry summers cracking wooden gates. Pomona’s summer heat dries out older wooden side-yard gates, causing cracks, warped boards, and latch misalignment. Automatic gate operators then strain against a gate that doesn’t sit square anymore, and the arm, gear, or limit switch fails. We see this constantly on original wood gates in neighborhoods around Ganesha Hills and Westmont.
- Photocells and loop detectors failing in tight layouts. When a slide gate gets crammed into a narrow Pomona setback, the safety photocell and vehicle loop detector often end up in awkward spots where they get hit, buried, or misaligned. We’ve made more than a few Pomona gates functional again simply by re-positioning the photocell and re-cutting the loop detector to match the actual driveway geometry.
See the difference
Before
After
Before
After
Before
AfterPricing for Electric Gate Repair in Pomona, CA
Gate opener repair in Pomona typically runs $180 to $400 for common fixes like a stripped arm, bad limit switch, or worn gear. Automatic gate repair involving a control board replacement lands between $300 and $700 depending on the operator brand and whether it’s residential or commercial. Full swing-to-slide gate conversions in Pomona usually run $1,800 to $3,600, and that includes the operator, rack and pinion, new post footings where needed, and safety photocell installation. Photocell or keypad replacement is typically $120 to $280. Every quote is written and agreed to before any work starts, so the invoice matches the quote. Call (877) 752-1896 for a free estimate on your specific gate.
We Also Serve Cities Near Pomona
Beyond Pomona, our Electric Gate Repair in Pomona coverage includes Claremont, Montclair, Los Serranos, and Upland. If you’re just over the city line in any of these neighboring communities, your gate faces the same Santa Ana winds, the same tight setbacks, and the same heat. Call us and we’ll be out.
Serving Pomona, CA — Our Local Coverage Area
We’re based in the Pomona area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Pomona
Yes, and this is one of the most common conversions we do in Pomona. A slide gate on a rack and pinion operator travels parallel to the property line instead of swinging out into the shared right of way, so it won’t hit anything. We convert swing gates to slide gates regularly on Pomona’s older tract homes and bungalows where narrow setbacks and shared driveways leave no room for a swinging panel. Call (877) 752-1896 and we’ll measure your driveway and give you a written price before any work begins.
The wind event most likely racked your gate, which means the gate twisted or shifted on its hinges and the opener then stripped its arm or sheared a pin trying to move it. On older wrought-iron gates in Pomona, the hinge posts have often been rusted or sagging for years, and the wind just finished the job. We replace the damaged operator parts and re-set the posts so the next Santa Ana doesn’t repeat the failure. We see a surge of these calls after every major wind event in Pomona.
The most common causes are a stripped or detached operator arm, a sheared drive pin inside the gearbox, or a limit switch that’s lost its setting. On LiftMaster swing gate operators in Pomona, we frequently find the arm has separated from the gate bracket after the gate was forced by wind or by someone pushing it manually. We’ll diagnose it on site, replace the broken component, and test the full travel cycle before we leave. Most of these repairs are completed in one visit, with parts already on the truck.
Yes. We service FAAC, BFT, DoorKing, LiftMaster, Elite, Mighty Mule, Linear, Viking, and Ghost Controls. We keep common boards, arms, gears, remotes, and photocells for these brands in our service vehicles so most Pomona repairs don’t require a follow-up visit for parts. If we don’t have the exact part for an older FAAC or BFT board, we’ll tell you honestly and order it rather than installing a workaround that fails in a month.
Yes. A safety photocell is what stops the gate when a car, person, or pet is in its path, and a gate that runs without a working photocell is dangerous. In Pomona, we routinely find photocells that were disabled, bypassed, or simply misaligned until they stopped detecting anything. We replace faulty photocells, re-align them to the correct height and angle for your driveway, and test them with an obstruction before we finish the job. This is not an optional extra; it’s part of a properly functioning automatic gate.
Call Baron Gate Repair for Electric Gate Repair in Pomona
If your automatic gate is stuck, running poorly, or failing after the last wind event, call (877) 752-1896. We’ll ask what the gate is doing, give you a straight answer on what we think it needs, and schedule a visit to your Pomona property. Estimates are free, the price is agreed before work starts, and the repair gets done by a gate specialist who has already seen your particular problem many times over.
Written by Nolan Briggs, Owner at Baron Gate Repair, serving Pomona and the surrounding San Gabriel Valley.